CRM Mitchell1, Author at Apex Vehicle Services

2010 Ford Edge
Mileage
182,143
Service Date
1/18/2023
Services Performed
Diagnose
INTAKE MANIFOLD GASKET – Remove & Replace – Upper
(Combination) – INTAKE MANIFOLD – Replace Upper
(Combination) – INTAKE MANIFOLD – Replace Upper & Lower
THROTTLE BODY CLEAN -clean throttle body, remove carbon build up and re-calibrate
SPARK PLUGS COMBINATION- Remove & Replace – [Includes: R&I Upper Intake Manifold.]
IGNITION COIL COMBINATION (ONE COIL) – Remove & Replace – All – [Includes: R&I Upper Intake Manifold.]
Landon F. gave our service a 5 star review on 1/19/2023
2011 Chevrolet Impala
Mileage
272,583
Service Date
12/31/2022
Services Performed
OIL PAN GASKET – Remove & Replace – [Includes: Lowering Subframe. DOES NOT include wheel alignment.]
WATER PUMP – Remove & Replace
LOF
Hubert T. gave our service a 5 star review on 12/31/2022
2007 Lincoln Town Car
Mileage
102,388
Service Date
12/19/2022
Services Performed
Diagnose Engine/Electrical
Remove factory ECM replace with Flagship One ECM
Cut new keys
Install Injector connector
Ben G. gave our service a 5 star review on 12/19/2022
2013 Ford F-350 Super Duty
Mileage
146,990
Service Date
12/16/2022
Services Performed
Mount and Balance 2 Tire
Alignment service
LOF
BALL JOINT – Remove & Replace – RWD w/Single Rear Wheels,All,Both Sides – [DOES NOT include alignment.]
IDLER ARM – Remove & Replace – RWD
CENTER LINK – Remove & Replace – RWD – [DOES NOT include alignment (unless noted otherwise).]
STEERING DAMPER – Remove & Replace
TIE ROD &/OR END – Remove & Replace – Inner or Outer – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some models
TIE ROD &/OR END – Remove & Replace – Each Additional – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some model
TIE ROD &/OR END – Remove & Replace – Each Additional – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some model
TIE ROD &/OR END – Remove & Replace – Each Additional – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some model
WHEEL BEARING – Repack – RWD Front,Both Sides – [Full Floating Axle.]
David I. gave our service a 5 star review on 12/16/2022
2017 GMC Yukon
Mileage
115,625
Service Date
11/21/2022
Services Performed
Complete Vehicle Inspection
Jeffery W. gave our service a 5 star review on 11/23/2022
2004 Ford Pickup
Mileage
2,124,932
Service Date
11/11/2022
Services Performed
added alignment w/another service
COOLING SYSTEM – Flush
STEERING GEAR (COMPLETE) – Remove & Install or Remove & Replace – F150 – [Includes: Bleed System.] – [Includes: Adjust toe-in on Rack and Pinion type Steering Gears. NOTE: Deduct .4 if alignment is also performed. DOES NOT include transfer of components.]
Install Camber Kit
Rotate & 4 tires
Abrahm C. gave our service a 5 star review on 11/11/2022
2020 Chevrolet Silverado 1500
Mileage
37,111
Service Date
10/27/2022
Services Performed
Rotate & Balance 4 tires
Brent O. gave our service a 5 star review on 10/27/2022
2008 Chevrolet Avalanche
Mileage
150,000
Service Date
8/19/2022
Services Performed
Remove and reinstall four wheels and rear brake drums to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front ( %) Rear ( %)
BRAKE SHOES &/OR PADS – Remove & Replace – Front or Rear – [Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.]
misfire on 1 and 3, metal on metal on front end, 4 wheel drive makes noise, intermediate shaft on steering shaft.
STEERING GEAR (COMPLETE) – Remove & Replace – [Includes: Manual and Power Rack & Pinion, Worm & Ball Nut and Rack & Piston Assemblies. Adjust Toe-in on Rack & Pinion models. DOES NOT include transfer of components or alignment.]
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment (where applicable).]
SHOCK ABSORBER – Remove & Replace – w/o Ride Level Control,Both
(Combination) – AXLE SHAFT – Replace Each
OUTPUT SHAFT SEAL – Remove & Replace – Both – [Includes: R&I Drive Axle Housing. Includes: R&I Shock Assembly.]
OIL PAN GASKET – Remove & Replace – 4WD w/Skid Plate – [Includes: R&I Front Differential.]
SPARK PLUGS – Remove & Replace
Mount and Balance 4 Tires
Alignment Check
STABILIZER BAR – Replace- Vehicle didn't have one.
(Additional) – STABILIZER BAR – Remove & Replace w/Skid Plate add
Sandy S. gave our service a 5 star review on 8/27/2022
2020 GMC Sierra 2500 HD
Mileage
1
Service Date
7/27/2022
Services Performed
Install Leveling Kit, 2020 GMC 2500HD Denali
Mount and Balance 4 Tires
Alignment service
Clay M. gave our service a 5 star review on 7/27/2022
2015 Chrysler 300
Mileage
71,416
Service Date
7/25/2022
Services Performed
Changed Motor Oil & Replaced Filter, Added 4 QTS Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels
TRANSMISSION OIL PAN GASKET &/OR FILTER – Remove & Replace – V6,RWD – [Includes: Additional time for use of scan tool to perform this procedure.]
Richard R. gave our service a 5 star review on 7/25/2022

CRM Mitchell1

We Service and Repair all CRM Mitchell1 cars